The temperature dependence of surface tension and density for Fe–Cr–Mo (AISI 4142), Fe–Cr–Ni (AISI 304), and Fe–Cr–Mn–Ni TRIP/TWIP high-manganese (16 wt% Cr, 7 wt% Mn, and 3–9 wt% Ni) liquid alloys are investigated using the conventional maximum bubble pressure (MBP) and sessile drop (SD) methods. In addition, the surface tension of liquid steel is measured using the oscillating droplet method on electromagnetically levitated (EML) liquid droplets at the German Aerospace Centre (DLR, Cologne). The data of thermophysical properties for Fe–Cr–Mn–Ni is of major importance for modeling of infiltration and gas atomization processes in the prototyping of a “TRIP-Matrix-Composite.” The surface tension of TRIP/TWIP steel increased with an increase in temperature in MBP as well as in SD measurement. The manganese evaporation with the conventional measurement methods is not significantly high within the experiments (∆Mₙ < 0.5 %). The temperature coefficient of surface tension (dσ/dT) is positive for liquid steel samples, which can be explained by the concentration of surface active elements. A slight influence of nickel on the surface tension of Fe–Cr–Mn–Ni steel was experimentally observed where σ is decreased with increasing nickel content. EML measurement of high-manganese steel, however, is limited to the undercooling state of the liquid steel. The manganese evaporation strongly increased in excess of the liquidus temperature in levitation measurements and a mass loss of droplet of 5 % was observed.
Kechagias, John, Iakovakis, Vassilis, Katsanos, Manolis, and Maropoulos, Stergios
Journal of materials science, 2008 Apr., v. 43, no. 8, p. 2522-2535.
models, electrodes, and manufacturing
Electrical discharge machining (EDM) is a non-conventional process for the manufacture of complex or hard material parts that are difficult to machine by conventional machining processes. During EDM, the electrode shape is mirrored in the workpiece. As a result, problems are transferred on the electrode manufacturing process. Rapid tooling (RT) is a new technology which uses rapid prototyping (RP) models to reduce the time and cost of tool manufacture. The various methods of manufacturing RT electrodes, with respect to different materials and the incorporated supplementary processes, are classified in the present work. Recent international research work on RT electrodes is reviewed and the results on the performance of RT electrodes are tabulated.
Journal of materials science, 2006 Jan., v. 41, no. 1, p. 177-198.
manufacturing, sensors (equipment), composite materials, and ceramics
The last two decades have witnessed the proliferation piezoelectric composite transducers for an array of sensor and actuator applications. In this article, a concise summary of the major methods used in composite making, with special emphasis on Solid Freeform Fabrication (SFF), is provided. Fused Deposition of Ceramics (FDC) and Sanders Prototyping (SP) are two SFF techniques that have been utilized to make a variety of novel piezocomposites with connectivity patterns including (1-3), (3-2), (3-1), (2-2) and (3-3). The FDC technique has also been used to prototype a number of actuators such as tube arrays, spiral, oval, telescoping, and monomorph multi-material bending actuators. It has been demonstrated that SFF technology is a viable option for fabricating piezocomposite sensors and actuators with intricate geometry, unorthodox internal architecture, and complex symmetry. The salient aspects of processing of such composite sensors and actuators are summarized, and structure-processing-property relations are elaborated on.